Fitting Instructions

Once your wall mural has arrived, the next step is installing it in your home. If you’re looking for some assistance – don’t worry, we are here to lend a helping hand! We’ve listed everything you need to know about your wall mural right here…

Tools you'll need

  • Tape measure
  • Pencil
  • Step-ladder
  • Spirit level
  • Squeegee/smoothing tool
  • Cutting knife
  • Straight edge for trimming
  • Sponge/cloth

2 heads 😁+😁 are better than 1 😔

It is advised that two people install the wall mural together to achieve the best results and make life a bit easier.

Take care ⛑

Take care when handling your mural – but the material is forgiving and will not tear or crease easily !

Please note ❗️

Unfortunately, we cannot accept any responsibility once the wall mural has been installed. If your wall mural arrives faulty, please contact via email at

Wall preparation

Preparing your wall is the most important part of the installation process. There are things to consider before you get started.

Check your mural

  • Lay out each panel to ensure you have everything and it matches up accordingly. Each panel is labelled in a chronological order to keep things simple.
  • If you notice any defects, please do not install your mural and get in contact with us as soon as possible.
  • We have supplied your mural with 30mm extra top, bottom, left and right to allow for misshaped walls.
  • We advise that you refer to these installation instructions. If you have any problems, don’t hesitate to ask us!

Final Preparation

The wall mural you have purchased is provided with 3cm of bleed (extra printed paper) to the top and bottom of each drop, be aware of this when installing.

Your mural has been designed to allow for a small overlap on each drop, which means that when lining up the next drop match up the image approximately 10mm in on the previous drop. Don’t worry the join will be pretty hard to see once the mural is complete.

Please ensure your wall has a smooth, dry and clean surface and you have removed all fixtures.

If your wall is dry and absorbent you may need to size your wall – this means priming your wall before applying the mural.

Installing Your Mural

Your mural will arrive in several ‘drops’ (panels) – these drops will be numbered in order of installation. For example, 1 is the first drop and 8 is the last drop.

The most important step is making sure the first drop is straight and level. This will affect all other drops of wallpaper on that wall, so it is vital to spend time getting the first drop correct.

This process of ensuring the first drop is straight should be repeated on starting each new wall. Don’t assume your walls are perfectly straight!

Mark a vertical line, 63cm from the left-hand edge. This will be a guide for your first drop.

Once your first drop is ready, carefully peel a small amount of the mural from the backing paper at the top approximately 10cm, fold this on itself and flatten.

Being careful not to cause any creases, apply the top of the mural to the wall whilst checking it’s straight against the vertical line you have drawn, with 3cm of bleed to the top.

Using a squeegee or smoothing tool, remove any creases or air pockets by smoothing out from the middle towards the sides of the mural.

It's best to pull down the backing paper about 30cms at a time. Hold the mural away from the wall carefully smoothing the mural onto the wall.

Continue to apply the panel until you reach the bottom of the wall.

If you need to reposition an area at any point, simply peel the section away and re-apply it, ensuring all creases are smoothed out.

Once the first drop is in place, hang your second drop as per the first, using the edge of the first drop as your guide.


When all panels have been applied to your wall, using your straight edge and a knife, trim the excess paper along the ceiling and skirting.

For a perfect finish always use a sharp knife or blade and make the cut in one clean movement.